C-Mn-Si低合金钢控轧控冷生产?准32 mm HRB400工艺与组织性能
CR-CC Process of ?准32 mm HRB400 of C-Mn-Si Low Alloy Steel and Its Microstructure and Mechanical Properties
赵文成 1, 张玉萍2, 齐长发3, 齐玉珍1
点击：3278次 下载：0次
作者单位：(1. 唐山科技职业技术学院 冶金系, 河北 唐山 063001; 2. 河北省唐山市规划建筑设计研究院, 河北 唐山 063000; 3. 河北唐钢集团技术中心, 河北 唐山 063016)
中文关键字：控轧控冷； HRB400； 组织； 力学性能
英文关键字：CR-CC; HRB400; microstructure; mechanical property
中文摘要：讨论了C-Mn-Si低合金钢控轧控冷生产HRB400的工艺流程、化学成分、力学性能、金相组织与强化机制，提出了合理的C、Mn控制目标。同时对实验中出现的问题进行了分析，提出了解决问题的措施。实验结果表明：C-Mn-Si低合金钢控轧控冷生产HRB400金相组织为F+P，钢筋心部和边缘的晶粒度为8.5级和9.5级，比热轧钢筋分别提高1.0～2.0级，力学性能符合HRB400的要求。
英文摘要：The controlled rolling and controlled cooling process, chemical composition, mechanical properties, microstructure and strengthened mechanism of the tested ribbed bar were discussed. The reasonable C, Mn content were proposed. The investigation of testing problem was carried out and some measures were proposed. The results show that the microstructure of the tested ribbed bar is F + P. The ferrite grain size in the center and surface of the tested ribbed bar is about 8.5 and 9.5 level, respectively, 1.0～2.0 level higher than that of hot rolled ribbed bar. The mechanical properties of the tested ribbed bar qualify for HRB400.